Electrical Installation Cortlandt Manor

Electrical installation mistakes are much common in every house and sometimes these can bring dangerous results. When you are working to design your dream house then it is highly important to pay more attention to Electrical installation to avoid any mistake in the electrical work because it always has dangers associated with them. Therefore, it is always important to pay more attention to the works related to Electrical installation and make it more than perfect to ensure the safety of your house in the best possible way.

Mistakes to avoid during Electrical installation
Well, here are some of the most common mistakes which you have to avoid during Electrical installation:

Exposed wires
This is one of the most common problems which you may have experienced a lot. Most commonly, these exposed wires can become a cause of short-circuiting and this can lead to worst results. Therefore, it is always important to pay attention to it. You can reconnect the wires again or can wrap them properly.

Scratched or rusted wires
When it comes to Electrical installation, it is always important to go with the best quality of wires which can't be rust or scratched. Most commonly, this problem occurs when you are not going to pay attention to the maintenance. So, it is highly important not to be careless about your electrical wire and cut the damaged part and strip it again to reconnect.

Too loose or short-cut wires
Whether you have left the wires too loose or have cut the wire too short, both of the situations are not suitable because these have tremendous risks associated with these. It is perfect to leave the wire just 3 inches loose so that you can move that around properly.

Unsecured wires
When you are going to install wiring, it is always important to secure all of them with a proper clamp to prevent strained connection or any damage. Selection of a suitable clamp normally depends on the type of box you are suing in your electrical work.

Improper recessed lights
When it comes to installing fixtures, it is always important to consider recess precautions to secure insulations in a proper way. So, it is not going to affect your wiring. The maximum distance between insulation and light fixture should be about 75mm to get a secure connection. So, these are some of the most common and important things which you need to consider while you are planning to get done with the process of electrical installation.